I attempted connecting my logitech 3d pro onto my mac and setting the acis with live flight connect i got it to assign weirdly cause as soom as i touch my joystick for calibration it already setted up whether it was pitch or yaw or anyone even y tried it in hame with the controls and network device and the controller when I attempt to play simply doesn’t move any axis help in setting this joystick would be appreciated thank you as always.
Hello Please Try This Link and come back if there Is any issues!: I believe the Logitech was tested with live flight so go ahead and read over it
"- This may help if you are looking only for live flight and not connecting it to an devices:
Plug the joystick into the PC/Mac and install LiveFlight Connect (if you have any issues, please send a PM to @carmalonso).
In Infinite Flight, go to Settings (top left corner), scroll to the bottom and enable Infinite Flight Connect.
Open LiveFlight Connect - if both devices are on the same network and Connect is enabled, it should quickly say “Connected!”.
Go to the Joystick tab.
If your joystick is recognised (should say “your joystick is setup correctly!”), skip this step.
LiveFlight Connect will try and auto-map axes if your joystick isn’t recognised. If something isn’t working right, tap reset axes. You will need to manually assign axes. Check this thread for more info.
It should look as below when done (with different numbers):
- In Infinite Flight, go to Settings, followed by Controls (fifth tab). Assign each flight control an axis by tapping on the corresponding button under Key/Axis, and assign buttons under the Commands tab."
Im having this exact same problem! Someone please help!
Use the link above, say the problem there
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.