Rsomers's ATC Tracking Thread - [CLOSED] @ N/A

I’m practicing my tower/ground work and would much appreciate it if some of you guys could come fly around Thunder Bay (CYQT) thanks!

1 Like

SRY man…
Wanted to help you out but I’m not used to small aircrafts.
Sorry again for bad ending pew…

1 Like

Hi there I’ll come and give feedback. :)

Hi there you don’t seem to be open at the airport stated in your title. When you do close be sure to announce so pilots don’t get confused and can confirm you are closed. Also, edit your title next time from open to close. I edited your title this time. :)

1 Like

it’s all good! Thanks for your help

1 Like

Sorry about that, thank you though

1 Like

Will you open again? :)

1 Like

Yeah going back now

Hi, tell me about the measurements of the asfalt please.

Thanks

1 Like

Comming in now.

1 Like

🥺 third times a charm. Let’s try this again, sorry.

1 Like

Are you still open?

1 Like

yup still open :)

runway 07 is in use 7283x200 :)

Good I shall join in a few minutes ;)

sounds good, much appreciated :)

1 Like

No problem, mate

1 Like

Amazing. Let’s go there

1 Like

Thanks a lot everyone, closing for today. I’ll reopen this thread tomorrow when I’m controlling CYQT again! :)

1 Like

Hey there, I was N922BW. A couple things to pay attention to:

  • Separation. The other pilot and I were too close, which is why I turned to create more distance. You told him to extend downwind, you should have instructed one of us to make 360 for spacing.

  • No need to over control. You issued a couple speed commands that weren’t necessary following the spacing issue. Same with calling base.

  • Don’t forget to give the exit runway command when landing.

Other than that, you did a good job correcting any mistakes you made. It’s a tricky airport. Keep it up and look forward to seeing you in IFATC in the future.

1 Like