From the API, can we get info on whether and when IF is treating AP speed in mach, or in knots ?
since there is no information on speed units, if we set AP speed to 180knots , it sets Mach 180
Thank you.
From the API, can we get info on whether and when IF is treating AP speed in mach, or in knots ?
since there is no information on speed units, if we set AP speed to 180knots , it sets Mach 180
Thank you.
In app this is done at FL280 (28000ft) - we’ll look into standardising this for the API. Thanks!
While ascending it’s fl280. While descending a bit variation.
Lots of times I’m seeing it toggle at less than 27900
Is there a way to get the trim settings from the API ?
Also is there a way to set spoilers state directly.
I’m missing these two from the app.
Thanks
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.